How to hot start a Cirrus SR22

The SR22 does not like to normally start when the engine is hot. I use a simple procedure to hot start my SR22.

My Method
1. Prime 5 seconds
2. Throttle 1/4" open, mixture cutoff.
3. Start cranking and slowly advance mixture.
4. Once engine starts to fire, go mixture rich.

Honestly I developed this through trial and error, I don't know exactly why it works but it does. I think this works because the prime step pumps cold fuel through the system to cool it down. Then cranking the engine with mixture cutoff pushes all the fuel and air bubbles out of the system, leaving room for clean fuel to be pumped in through cold fuel lies.

CPPP Method
At the 2015 CPPP in Williamsport we learned about another trick. Hot engine means hot fuel lines, which vaporize fuel (literally, fuel boils, air bubbles form). Engine doesn't want to start with part fuel part air being pumped in. You must cool down your fuel lines first.

1. Throttle closed, mixture cutoff.
2. Run boost pump only for 15 seconds and wait 30 seconds.
You filled the fuel lines with cold fuel from the tank, it will cool down the fuel lines.
3. Go to steps 1-4 in the first section.