Skip to main content

CFII Advice: trick to fly IFR into Linden Airport near minimums (KLDJ)


If you're going IFR to linden in real IFR weather, think twice about this. If flying is inherently dangerous, and if approaches to minimums are the most dangerous part of flying, then this particular approach is a compound. This approach should never be attempted by new IFR pilots with weather near minimums. If you're a seasoned IFR pilot, keep reading.

Newark Approach will force you to cancel IFR between the FAF and MAP. The MAP is the first opportunity to maybe see the runway. That means you're always cancelling IFR before you have visual contact with the runway, and you cannot go missed.

Recall that VFR minimums in Golf daytime is 1sm vis and clear of clouds. That means in daytime, as long as you have 1sm vis and can remain clear of clouds, legally, you can cancel IFR and continue the approach legally VFR pilot nav.

Visibility is the most important thing. It's 2.3nm from BAUTZ to the runway. So if visibility is less than 2.3nm you know you won't be able to see the runway when you pass through the FAF and turn towards the airport. When you pick up the AWOS, make a note of this "see/no-see' factor.

The IAP published minimums are 620' and 2.5nm. So they want you to see at least the REIL at BAUTZ. But you've cancelled by then so you're committed to do *something* and you better see the runway and fly a true direct course to it on runway heading maintaining altitude, doing anything else is extremely dangerous in those weather conditions and in that geographic area.

Now I would avoid at all costs flying this at minimums in low vis, but if you must, it's possible to do relatively safely with a trick I'm going to teach you.

You see, what we really have here is an incomplete approach. It is a GPS-A because of newark arrivals, otherwise it would be a GPS approach, lined up with runway. They don't want planes going missed right into the approach corridors of EWR.

But, with a small trick we can reconfigure the approach so the autopilot will fly us all they way to the runway.

In your flight plan, after MAP BAUTZ insert KLDJ as a waypoint. The autopilot will now turn right at BAUTZ and fly directly to the runway. You are at 620' so don't start descending yet. At 500fpm descent, it will take 1 minute to get to the threshold, in which time you'll travel about 1.5nm. The runway is 4200' long, or approximately 1sm.

On your GPS flight plan when you load the KLDJ GPS-A procedure you'll see:

GEZSY (FAF)
3NM TO BAUTZ
BAUTZ (MAP)
VANER

and you want to change it to this:

GEZSY (FAF)
3NM TO BAUTZ
BAUTZ (MAP)
KLDJ <-- INSERT
VANER

Now the autopilot will make that turn at BAUTZ direct to the runway and we have GPS distance and time remaining. However, the KLDJ waypoint is in the MIDDLE of the runway, not the approach end. We know the runway is 4140' (round to 1sm for simplicity). Subtract 0.5nm or 20 seconds to get the actual distance and/or time to the threshold. So when the GPS says 1.5nm remaining, you're actually only 1nm from the threshold.

Now you can use the seconds remaining and NM remaining to KLDJ to determine when you should start normal descent, and you'll know exactly where to look for the runway. You'll be on autopilot, you won't be hand flying and doing crazy stuff. Just fly the approach normally. Lined up with the runway, the approach will be much easier to fly, and runway easier to see with this technique, and you won't accidentally start descent too early and fly into a factory. (check NTSB for several fatal accidents that start early descend into LDJ).  If you're planning a 500fpm descent, then 60+20=80 seconds remaining to KLDJ is when you want to begin your 500fpm descent to the threshold, no sooner.

Since you cancelled IFR before you reach BAUTZ, so that VANER point is not useful anyway, but keep it in your flight plan for emergency use in case you need to pick up IFR again.




The key for unfamiliar pilots is to not even try this approach if visibility is < 2.5nm. You know you won't be able to see the runway when you turn out of BAUTZ.

With this reprogrammed GPS set up you'll be less likely to try to hand fly it or descend too early or get disoriented. You should not disengage the autopilot until you're in a position for a normal descent to the runway, which is about 1/3 of the way between BAUTZ and the runway.

It's good to think about the worst case scenario too, where you can't land. I would make a normal 180 degree turn to the right, away from EWR, fly the missed approach, radio ATC or EWR Tower and calmly tell them you need immediate IFR clearance, climbing through 1000' over LDJ direct VANER. You're flying away from newark so they won't panic. .

Warning: there are tall towers and factory chimneys right below the extended center line, so do not begin descent until you have positive visual contact with the runway, and can see the terrain below you. It's NJ, so lights don;'t always work, be especially cautious at night. Note that this procedure is NA at night.

It goes without saying, you should practice this first under VFR conditions. Use every opportunity with VFR weather to fly this approach as practice so when clouds are low you'll be ready.

Fatal Accidents at LDJ


"THE ACFT HIT THE TOP OF A 75' TREE & CRASHED JUST SHORT OF THE FAF. A WITNESS RPRTD THAT JUST BFR THE ACDNT, THE ACFT APPEARED TO 'POP OUT' OF A CLOUD AT ABT 100' AGL IN A DSCNT"




During a traffic pattern approach, the airplane turned onto final and made a controlled descent into power lines. Contact was made approximately 48 feet above the ground, on runway centerline, about 1,500 feet from the displaced threshold.


Comments

Popular posts from this blog

How to get anything on EBAY for free (and get away with it)

This article explains how to get anything for free on Ebay. This is very simple, proven and guaranteed to work. You can get, for example, an IPhone 4, a 64GB IPad 2, or even a Macbook Pro laptop for free. 1. If the seller does not use delivery confirmation, you already won. Just tell ebay you never received the item. They will always side with you (bhe buyer) and refund your money, including shipping, AT THE SELLER'S EXPENSE. There is nothing the seller can do. Ebay will not investigate further, they close the case.  I have hard numerous reports of this happening.  See this facebook thread  and this article . The buyer now has no item, no money, and in addition he is out the cost of shipping. Totally screwed. 2. If you are dealing with a savvy seller, they will use delivery confirmation. Don't worry, you can still get your item for free. After you receive the item, open a case and claim the item broken. Let's use an IPhone 4 as an example. Open a claim and say the me...

THE COPA CIRRUS SR22 PERFORMANCE REPORT

About this report This report was generated from data collected from 160 active COPA SR22 pilots. You can see the original survey here: http://tinyurl.com/sr22cruisesurvey . You can download PDF . Table of Contents What you will get out of this report Who were the pilots behind this survey What aircraft are counted in the survey Actual cruise speed and fuel flow Fuel flow vs TAS for NA lean of peak operations What is the most efficient altitude for NA SR22? Turbo SR22 performance at high and low altitudes Are TKS/FIKI planes slower? What is the fastest NA SR22 by generation? Who gets the best range? Are high hour NA SR22 engines slower and do they burn more fuel? How do LoP vs RoP performance compare? POH vs actual performance for NA Who is the fastest SR22? Conclusion About the author Frequently asked questions What you will get out of this report This report is for SR22 owners and buyers. How your SR22 performs compared to other SR22s How altitude affects perfo...

How to hot start a Cirrus SR22

The SR22 does not like to normally start when the engine is hot. I use a simple procedure to hot start my SR22. My  Method 1. Prime 5 seconds 2. Throttle 1/4" open, mixture cutoff. 3. Start cranking and slowly advance mixture. 4. Once engine starts to fire, go mixture rich. Honestly I developed this through trial and error, I don't know exactly why it works but it does. I think this works because the prime step pumps cold fuel through the system to cool it down. Then cranking the engine with mixture cutoff pushes all the fuel and air bubbles out of the system, leaving room for clean fuel to be pumped in through cold fuel lies. CPPP Method At the 2015 CPPP in Williamsport we learned about another trick. Hot engine means hot fuel lines, which vaporize fuel (literally, fuel boils, air bubbles form). Engine doesn't want to start with part fuel part air being pumped in. You must cool down your fuel lines first. 1. Throttle closed, mixture cutoff. 2. Run boost pum...